An exclusive feature to this loom is the patented moving breast beam controlled by springs. The breast beam is attached to the loom in such a way that it is free to move toward the harnesses when the shed is made and then back toward the weaver when the shed is closed again. The distance between the breast beam and the back beam actually changes during weaving. With this system a larger shed can be obtained with less tension increase in the warp and less effort from the weaver.
The advantages of this system are especially evident as you near the end of the warp. Even when the end of the warp is very close to the harnesses, a good shed can be made, thus saving yards and yards of wasted warp over the life of your loom.
The moving breast beam also brings on exactly the same warp tension each time the warp is advanced. The design of the loom includes a built-in raddle on top of the castle and a storage shelf for keeping everything you need within easy reach.
The Spring can be purchased with 8 or 12 harnesses. An 8 harness Spring can be converted to 12 harnesses with the 4 harness Spring Treadle expansion kit. The heddles and tie-up cords are of the Swedish Texsolv system that make them quite strong and non-stretching. The spring has two weaving widths 90 cm (36″) and 110 cm (44″). It comes standard with eight harnesses, ten treadles, 600 Texsolv heddles (Spring 90) and 800 Texsolv heddles (Spring 110), stainless steel reed 40-10 (10 e.p.i.) 12 cm (5″) inside height, friction brake, 2 lease sticks and 16 warp sticks. The Spring is made of lacquered beech and comes ready-to-assemble with clear instructions and tools.
- The little black wheels and Texsolv cords on my Spring Loom shafts
- Shafts and lamms not quite level on my Spring Loom
- Cord catching on my Spring treadle
- What to do with extra harnesses and lamms on Louet Spring
- Installing and using a Sectional on my Spring Loom
- Beater problems on an older Spring Loom
- Loom waste on the Louet Spring
- How to warp with two warp beams and one friction brake
- Can the Louet Spring be tied up as a Jack loom?
- Problems with the left side of the beams on an old Louet Spring