Forum Replies Created
March 27, 2021 at 11:19 am in reply to: Thoughts on 3.7.1 – Designing a Double Width Project #201134
I am finally trying my hand at double weave. I am a bit worried because I only have 10 dent and a 13 dent reeds. I can get the epi with the 10 dent one. I am threading it 1,2,2 to get 16 ends per inch. Do you have any thoughts on how this will affect the project?
Jane SullivanJuly 9, 2020 at 10:52 am in reply to: Thoughts on Fiberworks Mac & Windows – Introduction, Download & Installation Lessons #172657
I am just getting around to downloading the FIberworks for Mac. I have version Catalina 10.15.5 and everytime I try to open the download I get the message below.
“Bronze” cannot be opened because the developer cannot be verified.
Can you help?
I have finally put the warp for the scarves on my loom. I am now ready to tie on to the front beam. I have huge differences in the length between the silk and the wool. I have been tugging on the wool to try to even it out. Is this normal when using yarns so different together in the same warp?
JaneOctober 8, 2019 at 2:11 pm in reply to: Thoughts on 3.8.2 – Weaving Your Supplementary Warp Sample #155927
Hi Jane, I have a few questions to ask you. At one point, you mentioned that you wove the sample on a counter balance loom. Is the tie-up on the pdf for a counter balance loom or a jack loom? (I have just acquired a counter balance loom after weaving primarily on a jack loom) Will the tie-up be the same on both types of looms?
How do you accommodate a loom with 6 treadles instead of 8 to weave the sample? Is it as simple as changing the tie-up of the supplementary warp?
Thank you for helping me to be a much better and more efficient weaver!